For some ACT Science questions, you will need to be able to answer questions on how certain experiments are set up. These questions can appear in any of the three Science passages: Data Representation, Research Summaries, and Conflicting Viewpoints, but are much more common in Research Summaries. To improve your scores on Procedure questions, and achieve a higher ACT Science score overall, it’s important to extract the set-up from any experiment mentioned BEFORE moving on to the questions. Learn to take notes on your scratch paper while studying, just as you would on the actual ACT test.
Soap molecules often consist of long chains of hydrocarbons ending in a negatively charged ion. In water, the soap molecules form clusters called micelles. Soaps are able to remove dirt particles from surfaces by trapping them in the centers of the micelles.
A science fair student designs an experiment to measure the cleaning power of sodium oleate, a chemical that can be used as a soap. In the experiment, eight white T-shirts were stained with either dirt or ketchup. After the shirts were cleaned under varying conditions, the student rated how visible the stains were.
The student wishes to demonstrate that the cleaning action is due to the oleate, and not to the sodium. Accordingly, the student measures the cleaning power of potassium oleate, using 4 scoops of the soap to clean a T-shirt stained with ketchup and a T-shirt stained with soil, to show that the same results are obtained under these circumstances.
Here is how our scratch paper notes might look:
Experiment 1 –
- Purpose: to measure sodium oleate
- Method: 8 stained shirts (dirt or ketchup), then cleaned in various conditions
- Results: student rated visibility of stains
Experiment 2 –
- Purpose: to measure oleate
- Method: 2 stained shirts (1 ketchup, 1 dirt), 4 scoops of potassium oleate to achieve same results as Exp. 1
We must pay close attention to what was similar and what was different in the procedure. Both experiments dirtied shirts, then cleaned them. However, the number of shirts stained was different in each, and Experiment 2’s shirts were only cleaned to the extent that they matched the level of dirtiness left on the shirts from Experiment 1.
Procedure Practice Question
Here is how a sample “Procedure” question might look. We can identify it as such because it explicitly asks about the set-up of the experiments.
Experiment 2 differed from Experiment 1 in that:
A The amount of soap was varied only in Experiment 1
B The stain was varied only in Experiment 1
C The amount of soap was varied only in Experiment 2
D The stain was varied only in Experiment 2
Another way to think of this question is: “what changed between the experiments?” Looking at our notes, we can see that the cleaning solution changed (sodium oleate to potassium oleate), the number of shirts changed (from 8 to 4), and what was specifically being measured changed (in Exp. 1 it was the visibility of the stains, in Exp. 2 it was how many scoops to achieve the results of Exp. 2).
We can quickly eliminate B and D, since the stains were different (ketchup and dirt) within each experiment. Since Experiment 2 measured how much soap was needed to achieve the results of Experiment 1, then it’s likely different amounts were needed depending on the severity of the stain. In Experiment 1, it is implied that all of the shirts were uniformly washed with the same amount of soap, but the conditions of the washing were modified. Therefore the answer is (A).